>> Piezo Controller Catalog Download Site

>>Piezo Drivers and Controllers   >>Piezo Flexure Positioners   >>Piezoelectric Actuators   >>Piezo Tilt Platforms   >>Piezo Actuator Tutorial   >>Precision Actuators   >>Piezo Motors   >>Nanometrology Sensors   >>Photonics Alignment Solutions    >>Micropositioning Systems   >>Motion Controllers   >>6 Axis Positioners  
 

 

E-503.00 LVPZT Piezo Amplifier Module, 3 Channels

The Latest Information on E-503 Piezo Amplifiers

E-503.00 LVPZT Piezo Amplifier Module, 3 Channels

E-503.00

  • 3 x 14 W Peak Power
  • Output Voltage Range -20 to +120 V
E-503.00 is an amplifier module for Low Voltage PZTs. It contains three independent amplifiers that can output and sink a peak current of 140 mA and an average current of 60 mA each. E-503.00 can be operated in 2 ways:

  • Manual operation
The output voltage can be set by a 10-turn, DC offset potentiometer in the range of 0 to 100 Volts.

  • External operation
Output voltage is controlled by an analog signal applied to the BNC inputs, ranging from -2 to 12 Volts. Multiplying by the gain factor of 10, an output voltage range of -20 to 120 Volts results. The DC offset potentiometer allows for a continuous variation of the input voltage range between -2 V to +12 V and -12 V to +2 V (clich here).

For computer controlled operation, an E-515 16 bit DAC Interface/Display Module can be used (requires E-500/E-501 chassis).

For frequency response with selected LVPZTs see graph below.

BACK Technical Data


Hexapods    Piezo    Nanopositioning Catalog   Capacitive Sensors   Nanopositioning   Micropositioning   PI USA   Piezoelektronik
Piezo Linear Actuator  Capacitive Sensor  Micropositioning  Hexapod  Fiber Alignment  Motion Control  High Speed Steering Mirror  Nanopositioning System  Piezo Design  Piezo Driver  Piezo Drivers and Controllers