Industrial Laser Material Processing

Small Geometries – High Dynamic – Debris Protection

Machining platforms for creating tiny geometries in the micron range demand motion systems that provide a consistent, accurate and dynamic processing in multiple dimensions. As the size and mass of the manufactured parts may be challenging and particles may be formed during machining, the system components used need to be highly precise, stiff, robust and offer reliable performance.

Reference edge to support the alignment in the machine

Connector for purge air to create overpressure

Side seal and hard cover to protect against particles

Robust industrial IP65 connectors for flexible cable exit

Easy access to the lubrication system

Different encoder variants including absolute-measuring sensors offering nanometer resolution

Different stage widths for different loads and cantilever reduction

Synchronous servo motor
Heavy-duty recirculating ball bearings
Holding brake
Ability to run directly on 110/240 volt AC
>> L-417 High-Load Linear Stage

Ironless magnetic direct drive linear motors
Heavy-duty recirculating ball bearings
XY configuration without adapter plate
XY drag chain cable management
>> V-417 High-Load Linear Motor Stage

ACS SPiiPlus EtherCAT® network motion controllers and drive modules for optimum synchronization of the axes and simultaneous control of the laser
>> ACS Motion Controllers
The Laser Control Module (LCM) can control a laser source directly with full synchronization to the motion path. LCM is able to interface with a wide range of lasers such as DPSS, CO₂, excimer, fiber, Q-switched, picosecond, or femtosecond. It is also suitable for position based triggering applications for test and inspection tasks
>> ACS Laser Control Module